Industrial-data-systems IDS DT220 Manual de usuario descargar pdf (Pagina 44)

DT220 Users Manual version 1.a Hardware & Wiring

Parallel Printer Port – 25 pin D connector J2

Pin # Signal Name

1 Strobe Output

2 TTL Output 1 (Printer Data 1)

3 TTL Output 2 (Printer Data 2)

4 TTL Output 3 (Printer Data 3)

5 TTL Output 4 (Printer Data 4)

6 TTL Output 5 (Printer Data 5)

7 TTL Output 6 (Printer Data 6)

8 TTL Output 7 (Printer Data 7)

9 TTL Output 8 (Printer Data 8)

11 Busy (input)

18-25 Ground (GND)

Load Cell Terminal Block

The load cell terminal block is located on the (optional 0113 PCB) plug-in the Analog

Input card inside the DT220. The Sense +/- inputs are jumped to Excitation +/- outputs

disabled from the factory. If remote sense is to be used remove or cut the jumpers located

on the bottom of the card/PCB.

Pin #

Signal Name

1 + Signal

2 - Signal

3 + Excitation

4 + Sense (Disabled default)

5 - Sense (Disabled default)

6 - Excitation

7 Analog ground

1 2 ... 39 40 41 42 43 44 45 46 47 48 49

Sin comentarios

Industrial-data-systems IDS DT220 Manual de usuario Pagina 44