Industrial-data-systems IDS DT200 Manual de usuario descargar pdf (Pagina 30)

DT 200 Users Manual version 1.E Set Operation Parameters

2 - CONDEC: <st><polarity><weight><units><mode>>status><terminate>

Polarity: space (positive weight), - (negative weight)

Weight: 7 characters, zero blanked, with decimal point

Units: L (lb), K (kg), T (ton), G (gram), O (oz)

Mode: G (gross mode), N (net mode)

Status:

<space> (valid weight), M (motion), O (over wt), I(invalid)

Terminate: lf, cr (line feed, carriage return)

3 - WEIGHTRONIX: <mode1><mode2><polarity><weight><space><units><term>

Mode1: space (gross mode), 0 (zero if net mode)

Mode2: G (gross mode), N (net mode)

Polarity: + (positive weight), - (negative weight)

Weight: 6 characters, NOT zero blanked, with decimal point

Units: lb, kg, oz, g <space>(gram), t<space> (ton), tn (tonne)

Terminate: lf, cr (line feed, carriage return)

4 - OHAS: <polarity><weight><space><units><2 spaces><mode><status><term>

Polarity: space (positive weight), - (negative weight)

Weight: 7 digits, zero blanked, with decimal point

Units: lb, kg, oz, g <space>(gram), t<space> (ton), tn (tonne)

Mode: G (gross mode), N (net mode)

Status: <space> (valid weight), M (motion), O (over wt), I(invalid)

Terminate: lf, cr (line feed, carriage return)

5 - Print label 85: transmits the contents of parameter 85 (print label 85)

Data entered into a print label can include register data:

[253] [reg no] buffer register data, minimum size (zero blanked no spaces)

[254] [reg no] buffer data, 7 character field, zero blanked, right justified.

Printer Parameters

The DT200 provides a universal printer interface for various printers. The printer

interface allows you to select and customize the data output for serial or parallel printers.

The serial interface option uses Serial Port 1 (TB1) for connection to the printer. The

parallel interface uses the TTL I/O Port (TB4) for connection to the printer. Refer to the

“HARDWARE INSTALLATION AND WIRING “ section for information on connector

pin designations. NOTE: The parallel interface may not be available if the DT200 is

configured to use setpoint outputs.

Parameter 29 Printer Port Select (2 [Serial Port 1])

Enter a number from the following list to select a printer option:

1 Parallel Printer interface.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 57 58

Sin comentarios

Industrial-data-systems IDS DT200 Manual de usuario Pagina 30